FLANGED VIBRATION MOTORS

Flanged vibration motors that have maximum 2080 kgf (20,4 kN) centrifugal force are suitable for vibration machine manufacturer and other sectors in industry.

Miksan Motor’s flanged vibration motors can operate in all confitions and enviroments with high performance.

TECHNICAL SPECIFICATIONS

Power Supply

Power supply of vibration motors is 230 Volt singlephase or 230 ∆/400 Y Volt threephase and 50-60 Hz as a standart. Please contact us for the special voltage and frequency rate.

Electric Motor

Electric motor of flanged vibration motors has higher starting torques than standart asynchronous electric motor. Standart Miksan Motor singlephase flanged vibration motors have permanent split capacitor. Over heating problem of the vibration motor due to no vantilation system is taking into consideration at designing.

Polarity

As a standart vibration motors are manufactured in 2 or 4 pole.

Motor Shaft

Motor shaft of vibration motors is produced from C45 structural steel. 

Rotor

Rotor is produced by injecting high alloyed alluminium to the channel of the packed siliceous sheet metal. 

Bearings

The series with lower centrifugal force (from VYF to VCF series) are equipped with deep groove ball bearing (2Z) with C3 internal clearance. The series with higher centrifugal force (VDF and VEF series) are equipped with cylindrical roller bearings ( NJ Series) with C4 internal clearance. All of the bearings, that we are using, are suitable to operate at heavy duty conditions

Eccentric Weights

The weights can adjust easily by rotating or subtracting according to the type of the vibration motors.

Casing

Casing of vibration motor is high alloyed aluminium from VYF series to VEF series. For the casing of vibration motors that have higher centrifugal force (VEF series) is nodular cast iron (GGG 50).

Eccentric Weights Cover

The eccentric weights cover is sheet metal up to VK series. The purpose of the eccentric weight covers are protecting the eccentric weights from the external factors and providing the safety.

Insulation Class

Insulation class of our standart range vibrtion motor is F class (155 °C).

Degree of Protection

Degree of protection is IP 66.

Lubrication

Except the vibration motors that used self-lubricated bearings (deep groove ball bearings - 2Z), bearings of the vibration motors (NJ series) are lubricated in our factory. Apart from this, bearings have to be lubricated with the aid of grease nipple that is on the vibration motor case during the maintance. Required grease amount is written in the “ Vibration Motor User’s Manual.

Painting

Vibration motors are painted with RAL 1003 paint by using electrostatic painting method